CE Certificate for Needle Flame Burner

Dear All 

Our some test equipment listed as below has been tested and found in conformity with the European directives EMC 2014/30/EU and LVD 2014/35/EU:

1. Needle Flame tracking index tester ZLT-ZY2
2. Power Cord Flexibility Tester ZLT-JDW1R
3. Power Cord Strain and Twist Tester ZLT-LN1
4. Glow Wire Tester ZLT-GTR
5. Horizontal Vertical Flame Tester ZLT-HV50
6. Tracking Tester ZLT-LDQ1
7. Covering Scratch Test Machine ZLT-GC1
8. Inclined Plane Device ZLT-WD3D
The CE mark can been used and CE certificate is provided for needle flame test chamber ZLT-ZY2 manufactured by Zhilitong Electromechanical Co., Ltd.

Comments

Post a Comment

Popular posts from this blog

What are the parts that isn’t suitable for glow wire test?

Image
On the basis of IEC 60335-1 clause 30.2.3, glow wire test apparatus of IEC60695-2-11 is not applicable to  some parts of electrical appliance as below: 1.  Parts supporting welded connections 2.  Parts supporting connections in low power circuits described in 19.11.1 3.  Soldered connection on printed circuit boards 4.  Connections on small components that are mounted on printed circuit boards 5.  Parts within 3 mm of any of these connections Note Examples of small component are diodes, transistors, resistors, integrated circuits and capacitors not directly connected to the supply mains. The glow wire test apparatus   ZLT-GTR produced by Zhilitong Electromechanical Co., Ltd , conforms to requirements of IEC60335-1 standard.
Read more

The comparison between new and old standard for glow wire tester（1)

Image
The newest IEC60695-2-10:2013 standard for   glow wire test apparatus was carried out for some years , compared with the old standard, the requirements of glow wire loop , thermocouple, silver foil test temperature has been updated. First, according to old standard , the demanded thermocouple wire diameter is 0.5 mm, but the new standards for the wire diameter requires 1.0mm, which would lead corresponding change for glow wire loop .  The thermocouples which are mounted in  glow wire test apparatus  ZLT-GTR manufactured by  ZHILITONG Electromechanical Co.Ltd , are purchased from B+B  company, with 1.0mm wire diameter, K type, insulation against ground,complying with above requirements of newest IEC 60695 standard.
Read more