Zhilitong Electromechanical Co.,Ltd

According to UL 153, a printed wiring board,including coatings, when provided shall comply with the requirements in the Standard for Printed-Wiring Boards, UL 796, and shall be classified V-0, V-1, or V-2 in accordance with the Standard for Test for Flammability of Plastic Materials for Parts in Device and Appliance,UL94.   UL94 Burning Tester   manufactured by Zhilitong Electromechanical Co., Ltd , meets with above requirements of UL 153, UL 94, and can perform test of classified V-0, V-1, or V-2 

Dear All  Our some test equipment   listed as below has been tested and found in conformity with the European directives EMC 2014/30/EU and LVD 2014/35/EU: 1.  N eedle F lame  tracking index tester  ZLT-ZY2 2. Power Cord Flexibility Tester ZLT-JDW1R 3. Power Cord Strain and Twist Tester ZLT-LN1 4. Glow Wire Tester ZLT-GTR 5. Horizontal Vertical Flame Tester ZLT-HV50 6. Tracking Tester ZLT-LDQ1 7. Covering Scratch Test Machine ZLT-GC1 8. Inclined Plane Device ZLT-WD3D The CE mark can been used and CE certificate is provided for  needle flame test chamber  ZLT-ZY2 manufactured by  Zhilitong Electromechanical Co., Ltd.

In 2017 , our company successfully cooperated with Intertek Testing Service New York Branch and supplied them   IEC62368 Straight Unjointed Test Probes   ZLT-U01A, which is our new product and conform to latest requirements of IEC 62368-1: 2014 Edition Annex V and figure V.1 . Following please see corresponding copy of certificate :

According to IEC 60998 clause 19 , u nless otherwise specified parts of insulating material retaining live parts in position shall be of   material resistant to tracking index tester   . The test is performed according to IEC 60112. A flat surface of the part to be tested at least 15 mm × 15 mm and at least 3 mm thick is placed   in the horizontal position on the apparatus , The material under test shall pass at a proof tracking index of 175 V using the test solution A   with an interval between drops of 30 s ± 5 s. The tracking index tester   ZLT-LDQ1 manufactured by Zhilitong Electromechanical Co., Ltd not only meets with IEC 60112, but also IEC 60998 standard, a bottle of ammonium chloride 99.8% purity is provided , to compound test solution A 

On the basis of IEC 60335-1 clause 30.2.3, glow wire test apparatus of IEC60695-2-11 is not applicable to  some parts of electrical appliance as below: 1.  Parts supporting welded connections 2.  Parts supporting connections in low power circuits described in 19.11.1 3.  Soldered connection on printed circuit boards 4.  Connections on small components that are mounted on printed circuit boards 5.  Parts within 3 mm of any of these connections Note Examples of small component are diodes, transistors, resistors, integrated circuits and capacitors not directly connected to the supply mains. The glow wire test apparatus   ZLT-GTR produced by Zhilitong Electromechanical Co., Ltd , conforms to requirements of IEC60335-1 standard.