The fire hazard testing for LED lamp

LED  lamp has various shapes, for example the fluorescent lamp tube type LED , same as ordinary fluorescent lamp , power module and a light emitting diode are sealed inside fluorescent tube shaped transparent polymer shell which also provide fire and electric shock prevention .
According to the requirements of UL standards, the shell material of energy-saving lamp shall reach at least V - 1 flame resistance level which is determined by UL94 Burning Glow wire test apparatus

Zhilitong Electromechanical Co., Ltd supply UL94 Burning Tester ZLT-UL94 which can carry out the test flame power 50W and 500W combustion test

Comments

  1. UnknownJanuary 30, 2018 at 5:02 PM

    In my opinion, another glow wire tester with high quality may help you in the fire hazard testing.

    ReplyDelete

Post a Comment

Popular posts from this blog

What are the parts that isn’t suitable for glow wire test?

Image
On the basis of IEC 60335-1 clause 30.2.3, glow wire test apparatus of IEC60695-2-11 is not applicable to  some parts of electrical appliance as below: 1.  Parts supporting welded connections 2.  Parts supporting connections in low power circuits described in 19.11.1 3.  Soldered connection on printed circuit boards 4.  Connections on small components that are mounted on printed circuit boards 5.  Parts within 3 mm of any of these connections Note Examples of small component are diodes, transistors, resistors, integrated circuits and capacitors not directly connected to the supply mains. The glow wire test apparatus   ZLT-GTR produced by Zhilitong Electromechanical Co., Ltd , conforms to requirements of IEC60335-1 standard.
Read more

The comparison between new and old standard for glow wire tester（1)

Image
The newest IEC60695-2-10:2013 standard for   glow wire test apparatus was carried out for some years , compared with the old standard, the requirements of glow wire loop , thermocouple, silver foil test temperature has been updated. First, according to old standard , the demanded thermocouple wire diameter is 0.5 mm, but the new standards for the wire diameter requires 1.0mm, which would lead corresponding change for glow wire loop .  The thermocouples which are mounted in  glow wire test apparatus  ZLT-GTR manufactured by  ZHILITONG Electromechanical Co.Ltd , are purchased from B+B  company, with 1.0mm wire diameter, K type, insulation against ground,complying with above requirements of newest IEC 60695 standard.
Read more